Nov 17, 2023 | Cases, Milling, News
Case Study: Onshore, Asia +250 ft of Dual-String Section Milling completed with 2-access cuts and 3-milling runs at +9,700 ft! The Dynasty Energy Services Team was approached by a company in need of section milling a challenging well in Asia. Given the depth,...
Dec 14, 2020 | Cases, Milling
Well Location: Offshore California, USA. Operator Challenge: Operator needed to P&A the well while maintaining all casing strings integrity, pass through the 9 5/8” OD, 43#, 8.755” ID casing then section mill a 25’ window in the 13 3/8” OD, 72#, 12.347” ID casing....
May 22, 2020 | Cases, Deepwater, Fishing
LOCATION: Deep Water Gulf of Mexico, USA. – Keithly Canyon CHALLENGE: Operator had set inflatable packer for negative test on surface casing. During operation, packer lost pressure and slid down hole to undetermined depth. DYNASTY SOLUTION: Retrieve inflatable...
Mar 10, 2020 | Cases, Fishing
LOCATION: Wray, Colorado, USA CHALLENGE: Sand line parted with over 300’ of sand line remaining inside of 4 ½” ll.6# casing. Rig company ran a bit in well in attempt to “push down” the parted sand line below the perforations. This resulted in a “bird’s...
Jan 15, 2020 | Cases, Fishing
SCOPE: Cut Production Tubing above production packer and pull/lay down production tubing and accessories. Design & execute fishing procedure to retrieve production packer and tubing. LOCATION: Louisiana Inland Waters – Vermillion Bay OPERATOR: Well required the...
